People when opting for a particular car or a vehicle, will look for its mileage, name, making etc. now-a-days they look for the added facilities also. They want vehicles which are economic and which will provide latest features. These may include music systems also. Customers prefer listening to music when they are on a long drive. Thus the devices like music systems, radio, speakers are fixed in the cars. If they do not work, they can be repaired or changed. There are systems available in the markets for this. This article will tell you how to install a jeep wrangler radio.

You should take the following things for the installation of a new wrangler radio in your jeep. They are panel tool, Phillips screw driver and a wrench of 10 mm. The first thing needed for this is you should remove any tapes, CD which is already running in the system which you are going to remove. The next thing is you should turn off power of the vehicle. Then the negative connection of the battery should be removed so that you can avoid any short circuits or shocks that you might incur during its installation.

There are few things which have to be done for safety purpose. First remove the media which was playing, like the cd. The brake is set. The ignition system of the car is put out. The negative of the battery is disconnected. Then the vent of the trim is peered with the help of the panel kit. The panel's top side is revealed. It is observed to be long and is provided with vents. It is found near the receiver.

Then the next step you should do is to remove the entire trim panel. This is done so that the Phillips screws are best exposed and those two screws are carefully removed after removing the panel. Next thing you have to do is to remove the other set of screws. This can be done only after prying up the trim panel. This is done with the help of panel tool. Those screws are located at the radio's edge.

The screws that hold the panel of climate control in place is taken out. It is generally two in number. This panel of climate control is right below the opening of the radio. There is a retaining strap and this is found on the inside of the glove box of the jeep. Therefore, this glove box is opened and the strap is slid out carefully. Then, the glove compartment is lowered so that it is out of way.

Then you should remove a bolt of 10 mm. It is used to hold the radio in its position. This work is done with the help of the wrench. Thus now the radio can be safely removed from the dash by disconnecting all the wirings and other installations. The antenna plug should also be removed.

Now the new radio is taken. The wires and the antenna are connected to their respective sites. Then it is placed and bolt is tightened. Now the screws which we removed are fixed back to their place.

Thus the article helps you to know how to install a jeep wrangler radio. Thus you can enjoy your latest music with the newly installed one.