The moment you finish up designing your art work and also made an order of the materials to frame you will start to think of framing your art work designs. When you begin, look for a flan working surface like the kitchen counter or even a large table in your place. Use a Kraft paper, a table pad or corrugated board to protect your design from being destroyed. People in Ireland who want to do the job of picture framing Dublin are asked to follow the procedure that has eight steps.

All the packages that have been ordered for the work are opened and assembled neatly to simplify the work. Make a confirmation to see whether all the items that you ordered have been delivered and also do not throw the materials used for packaging until your design has been framed to your satisfaction. When the packaging is delivered, check to see if they have given you the instructions for framing.

Assemble needed tools for you to work easily without distractions. Make sure that you have also gathered the essential tools like screw driver, wire, linen tape and also acrylic cleaner. You can order some other tools and accessories from the online market in Ireland to simplify your work but this is not really important.

Start to fix your art designs at the back of foam core then tape or even hinge a mat sheet to the mat board or foam core. Choose one that you prefer. Then keep them aside as you do other remaining procedures.

Next step is to make a preparation of the acrylic. The protective liner is peeled on the side that is expected to be in touch with the art. That side is placed facing down on your collection of art which is the picture and the board. When through, peel off the remaining side. If you made a order of acrylic made with ultra violet rays or non-glaring properties, that part should face up and it should be indicated in the bought package.

Next step is that of framing. If you are using metal frame, start with its bottom and the side rails placing them facing down on your counter or surface. Next slide your art frame to the half assembled frame. Place that frame treatment facing down and then insert its top tail fixing all corners. Next insert the clips beneath the frame channel to give it a good, tight fit. Then attach bumpers and hanging hardware.

If the frame you are working with is wooden then it is delivered assembled if its matted length and width is fifty four or less. You proceed from putting it face down and then placing the art face down on inside it too. The art is secured within using clips. The hanging hardware and wires are then screwed. Some framers use point drivers for securing the art into the frame. To get a finished look at the back a double stick tape is run along edges of the frame and a Kraft paper attached. The excess is trimmed off and hanging ware and bumpers attached.

Before hanging you should polish off the finished piece of work using squirts of acrylic cleaner from Novus. This is done in order to ensure the end product of your labor is looking great and of course presentable to anyone looking at it.